How to install a manual boost controller MBC
This is the most common modification to a Subaru Impreza WRX and STi and is typically the first thing done. However, manual boost controllers can be found on other turbo vehicles and the installation is basically the same. Manual boost controllers work using a spring loaded restricter pill or ball that can be adjusted. When adjusted, this determines how much pressure is needed from the turbo to open the wastegate. It's a very simple device but can be tricky to install. Use the diagram below to help with installation.
diagram(2).JPG
- Remove old restricter pill lines that connect the wastegate to the turbo outlet vac port.
- Disconnect original OEM electric boost controller sensor line.
- Take the extra line removed and connect it to either side of your new MBC.
- Connect the exit port of the MBC to the turbo inlet vac port.
- Connect the entrace to port of the MBC to the wastegate vac port.
- Mount MBC anywhere you please, close is better because less chance of a leak.
- Adjust MBC according to manufacturers directions how many PSI you want to increase, or decrease.
Warning: Installling a MBC on a vehicle that is untuned is dangerous to the engine if you tune for too much boost. Keep an eye on your air fuel ratio and make sure you aren't running lean. At wide open throttle, the Subaru's like 11.2. It's best to modify the intake and exhaust and remove all restrictions before cranking up the boost. It's safer on your engine and the hot air from the turbo won't linger around as long in the motor which can lead to premature fail. Most people blow there engines by getting boost happy with the MBC.
Tip: If the vacuum lines won't budge, don't use grease or any oil based lubricants. Use rubbing alcohol to slide them on and off. Rubbing alcohol evaporates, grease doesn't. Greasing the lines will make them fall off. The last thing you want is a non-working boost controller. Bang!